|
PRODUCT: ETERNABOND ALUMIBOND / A-SEAL, ALUMINUM FACED PEEL/STICK FLASHING / WATERPROOFING TAPE. 2" WIDE x 50' LONG ROLL. PRICE/ROLL.
APPLICATIONS:
Eternabond A-Seal is recommended for all types of metal roofs including:
- Trailers
- RV's
- Mobile homes
- Industrial buildings
- Roof awnings
- Truck Trailers
FEATURES:
Eternabond roof leak repair tape has a heavy aluminum facing (requires no UV
protection).
The aluminum facing is 4-mil thick aluminum sheet (not 2-mil foil like
roof-seal most tapes).
Tape is 20 mils thick.
The specialized backing has proven to be UV stable, even after 16 years in
full sunlight.
The patented adhesive has an integrated primer which allows RoofSeal to BOND
with the surface it is installed on.
Perfect for re-seaming all roofs, regardless of the material, RoofSeal makes
a permanent water-tight seal (except silicones). Also great for tank repairs.
Elongation factor greater than 700% guarantees RoofSeal will flex, expand and
contract in all conditions, even on liners!
Can be installed to -20 degrees F (with EternaPrime).
Sag rating of over 250 degrees F. 10 year warranty.
SURFACE PREPARATION:
The surfaces to be sealed must be clean, dry and free of
loose rust, scale, dust, talc and dirt.
All oil, grease, silicone or other contaminates should be
first removed with a suitable solvent/cleaner.
For older roofs use a stiff brush to remove all loose
granules and surface elements.
APPLICATION:
Install Eternabond RoofSeal by gradually peeling away the plastic release
liner while rubbing the RoofSeal into the surface.
Hint: prevent bubbles under the product by using
your hand to squeegee out air by wiping your hand towards the roll as you set
the tape to the surface.
Overlap RoofSeal from the repair area to a good area by a
minimum of 2 inches.
Overlap RoofSeal to RoofSeal seams by a minimum of 2
inches.
Important: Use a roller to
activate the MicroSealant and permanently set RoofSeal to the surface.
SPECIFICATIONS:
Adhesion: > 9 lbs per inch of width
Elongation: >500%
Tensile Strength: 4500 +/- 500 PSI
Application Temperature with no Primer: 40F to >+150F
Application Temp. with Optional EternaPrime: -25F to +40F
Operating Temperature: -70F to >+200F
Sag Temperature: >200F.
Low Temperature Flexibility: 1/2" radius at -30 degrees F
Pliability: No cracks in membrane
Shelf Life: Up to 5 years
Manufacturers Warranty: 10 Years
COMPOSITION:
Eternabond RoofSeal utilizes Eternabond's advanced MicroSealant technology. It
features a 100% solids proprietary formulation of synthetic resins,
thermoplastics and non-curing rubber (not butyl) and a built-in primer. The
MicroSealant is bonded to a tough UV staple backing. The facing side of the
MicroSealant is then covered by an easily removed plastic release liner.
INSTALLATION TOOLS: The tools below are
suggested, and will make easy work of this!
Similar terms: eternabond a-seal, a-seal, eternabond tape, metal
roof repair, RV roof repair, patio roof repair, trailer roof repair, aseal,
steel roof repair, aluminum tape, aluminum faced tape, aluminum siding repair,
metal roof sealant, seam sealant
|