PRODUCT: Lucas 734 Cold Process Adhesive. 5-Gallon Pail. Price/Pail.
(Special Order Minimums apply; combustable item; UPS or Truck shipping only)
DESCRIPTION: A cold-process inter-ply adhesive for SBS modified bitumen single-ply membranes, black color. Lucas 734 Mod-Bit Adhesive is manufactured from refined modified asphalts, a special solvent blend, and non-asbestos reinforcing fibers. #734 is formulated to spread easily and evenly at the recommended rate of application.
Lucas Mod-Bit Adhesive should only be applied to surfaces that are sound, clean, and dry. Temperatures should be a minimum of 40° F and there should be no threat of rain. The adhesives may thicken in cold weather. To improve cold weather applicability, store the adhesives in a warm place prior to use. Apply directly from the can; do not thin. The SBS modified bitumen sheets should preferably be cut into sections less than 20 ft. in length and allowed to relax and flatten out before being installed. All laps should be a minimum of 4 inches wide. All laps should be rolled with a weighted roller and end laps should be weighted to insure a proper bond. A bead of adhesive should be evident at all seams. The adhesive may be left open for a short time before the modified roll is embedded to allow some of the solvent to evaporate and improve the initial bond. This time period will vary significantly with weather conditions and the applicator should be careful not to allow the adhesive to set up or skin over before the membrane is installed. Equipment and foot traffic should not be permitted on the new roof until the adhesive has fully cured in order to prevent voids or blisters from forming at pressure points. Lucas #734 Brush Grade should be applied evenly at a rate of 1.5 to 2 gallons per 100 sq. ft., depending upon the absorbency of the substrate. It may be applied with either a brush, roller, suitable spray equipment or, the preferred method on smooth surfaces, a notched squeegee with notches 1/4 inch wide and 1/8 inch deep spaced 1 inch on center. Excessive rates of application may damage the membrane and prolong curing time. Consult the modified bitumen manufacturer if more than one coat of adhesive is to be used in any roof system. Cure time will be between 24 and 48 hours. The strength of the adhesive will continue to increase beyond this initial bonding period. Clean up with mineral spirits.
Container Sizes: 5 Gallon
Email us at firstname.lastname@example.org or
Call us at 1-800-474-7570 or 602-272-8128
You'll get a prompt reply!
similar product terms: wet dry cement, wet/dry cement, wet patch, roof cement, lucas 776, lucas 776 elite, lucas roof cement, lucas elite, flashing cement, rubberized flashing cement, wet/dry flashing cement, henry 505, henry 208, henry 906, henry flashmaster, karnak 19, karnak ultra 19, flashmaster