PRODUCT:

1 inch Diameter Poly Backer Rod, Closed Cell, Non-Stick Skin, 550 Feet/Carton. Price/Carton.

ORDERING NOTES:

• UPS shipment only.

DESCRIPTION:

Round, resilient, polyethylene extruded closed celled foam with a water resistant outer skin. Provides controlled depth for sealants. Compresses up to 50 percent in smaller sizes and 30 percent in large sizes. Does not stick to sealants. Exceeds ASTM standards for bond breakering materials. No bond breaker is required. Very high moisture resistance. Will not absorb ground water. Compatible with all know types of sealants including butyl, polyurethane, silicones, tri-polyimer, polysulfide, acrylic, etc.

Color is generally charcoal, but can be gray also, and is not selectable.

APPLICATIONS:

• High moisture environments
• Ground based expansion joints
• General purpose sealant backing
• Use together with self-leveling sealant
• Highway joints
• Parking garages
• Around perimeters of door and window frames
• Coping and glazing joints
• Log Home chinking
• Isolation joints

SIZING CLOSED CELL BACKER-ROD:

Select a backer-rod diameter that is approximately 25% larger than the width of the joint.

APPLYING BACKER ROD:

1. Joint or opening should be clean and dry and free of all contaminates, loose materials, dry, and free of water or frost.

2. To install, compress backer-rod into the joint before sealants are applied. Joint or opening should be clean and dry and free of obstructions. Install backer-rod using a blunt probe or a plain faced roller to force the rod to the desired depth.

3. Compress to a depth of about 1/2 of the width measured at the crown of the backer rod.

4. A template or roller gauge may be used to control the depth at which the rod is placed.

5. Do not stretch, puncture or tear backer-rod during installation but gently force into the joint so that the backer-rod fits tight against the sides of the joint.

PRIMING:

1. Follow suggestions for joint-sealant application as directed by sealant manufacturer.

2. Where priming of the joint is necessary, primer should be applied only to the joint surfaces and allowed to dry before Backer-Rod is placed. DO NOT prime Backer-Rod.