PRODUCT: Large Size Retrofit GRAY EPDM Roof Pipe Flashing. Fits 3-3/8 to 10-inch (85-255 mm) round pipes, on up to 10/12 pitch roofs. 14-1/2 inch diamater round base, with stainless steel closing clamps. Price/Each. (aka DEKS RF803G, smaller size shown in photo)
DESCRIPTION: Retrofit flashings (also called a split flashing/or split boot) are used in applications where you cannot slide the flashing over / down a penetration.
The retrofit flashing can be split, which allows you to wrap around the pipe penetration and seal.
Base is 14-1/2" (369 mm) diameter.
FASTENERS AND SEALANT: Includes stainless steel clamp fasteners for closing/sealing the side. Screws for attaching to roof are not included. Additional sealant is recommended along the bottom, side seal, and top.
Flexible Base Design:
Sealing tightly with sealant and fastener, the infinitely flexible base is compatible with virtually any roofing material -- metal, plastic, asphalt, tile, rubber membrane, and more.
The heavy rib at base design makes flashing boot easily adaptable to various roof pitch. Increase ONE size for high pitch roofs.
* Plumbing, heating/air conditioning vents and equipment.
* Electrical service entrances.
* Solar pipes.
* Grain augers.
* TV antennas and aerials.
* Masts, vents or pipes through decks or bulkheads
* Pest control
EPDM BOOT PROPERTIES:
* Ozone Resistance > 70hours@50pphm
* Temperature Service:
....Intermittent: +135C (275F)
....Continuous: +100C (212F)
* Low Temperature Service: -55 (-65F)
* Tensile Strength: 10 MPa (145 psi min)
* Elongation at Break: 25%
WARRANTY: Manufacturer provided 20 year limited warranty.
related terms: rf901re, deks retrofit, deks round retrofit, deks retrofit flashing boot, springspeal flashing boot, 101rf, retro master flash, retro master flash, retrofit pipe flashing, retrofit pipe boot, retrofit flashing boot