#2 Square-Base Pipe Master Flashing – RED SILICONE

Product:

#2 Master Flash RED SILICONE Pipe Flashing Boot, 20 Year Warranty. 6X6 inch Base X 3 inches High with 3/4 inch open top. Fits 7/8 – 4 inch Pipes (22mm to 101mm). Price/Each.

Description:

The #2 Master Flash RED SILICONE Pipe Flashing Boot, backed by a 20-year warranty, features a 6X6 inch base, stands 3 inches high with a 3/4 inch open top, and fits pipes ranging from 7/8 to 4 inches (22mm to 101mm).

Features

• Flexible Base Design: Sealing tightly with sealant and almost any type of fastener, the flexible base is virtually compatible with any roofing material – metal, plastic, asphalt, tile, rubber membrane, and more.
• Resilient Design – Performance is unaffected by: Ice/snow, Hail stones, Vibration, Expansion/Contraction.
• Environment Control: Provides a permanent seal that controls gaseous or liquid environments to eliminate leakage and odor contamination.
• Corrosion-Resistant Base: Made of heavy-duty aluminum alloy for flexibility and corrosion resistance.
• Roof Pitch-Adaptability: The stepped-cone design makes flashing easily adaptable to most roof pitches.

Applications:

• Hot Pipes, Heater Pipes, Stove Pipes, Gas Vent Pipes
• Chemical Pipes, Corrosive environments
• Extreme Service Environments.
• Plumbing, heating/air conditioning vents and equipment
• Electrical service entrances
• Solar collection pipes
• Grain augers
• TV aerials
• Masts, vents or pipes through decks or bulkheads
• Lighting conductors
• Pest control

Warranty:

• Manufacture provides 20 year limited warranty.

Installation:

• Select And Trim: Choose appropriate size opening at least 20% smaller than pipe diameter. If necessary trim opening to 20% smaller than pipe diameter.
• Slide: Slide down over pipe. (A non-petroleum base lubricant will ease installation.). Use RETRO-FIT Flashing where pipe is not accessible.<
• Form: Press down, bending it to conform to roof profile or roof irregularities. A blunt tool will help press flashing into tight roof angles.
• Seal: Apply a bead of sealant between Master Flash base and roof and at top edge to pipe.
• Fasten: Use exterior grade fasteners with sealing washers to complete sealing. For UPC installation, fastener spacing may not exceed 1-1/2 inch (38mm).