Lucas 8800 Universal Bonding Adhesive 1G

PRODUCT:

Universal Bonding Adhesive 8800 by Lucas. Low VOC Water based contact adhesive for securing EPDM, TPO, PVC and other single-ply membranes to roofing substrates. 1-Gallon Pail. Price/Pail.

ORDERING NOTES:

• Shipping Leadtime:

DESCRIPTION:

Lucas #8800 Universal Bonding Adhesive is manufactured from strong, elastic, low Tg polymer resins and special additives in a water vehicle. #8800 exhibits permanent strong adhesion. Fast drying with an aggressive tack, #8800 bonds instantly without the risk of fire associated with flammable solvent based adhesives. VOC compliant in all areas. CAUTION: Must keep from freezing before use. In cold conditions, a Solvent Based product is recommended (see LG-BA10 link below).

applications:

• LOCATIONS: Can be used in all geographic locations. Water Based Low VOC adhesive, suitable for all locations. Can be air shipped.
• MEMBRANES: Secures EPDM, TPO, PVC and other single-ply membranes. No primer is required to fresh clean surfaces.
• SUBSTRATES: Suitable for use on Polyisocyanurate, Recovery Board, Dens Deck Prime, OSB, Plywood, Metal, Foam, Cellular lightweight concrete, and Structural Concrete.
• REPLACES: Used to replace solvent-based, low VOC and other water-based adhesives systems.

coverage:

• Using a 1/2 inch nap roller, about 60-100 sq.ft. per gallon on most surfaces (120-200 sq.ft./gallon per side).

installation:

It is applied to both membrane and substrate; allowed to dry until no longer wet to touch; then two tacky surfaces are carefully mated together; then the membrane is rolled to fuse surfaces.

• Stir until settled material or phased liquid is redistributed and the adhesive is uniform in color.
• Apply adhesive to the substrate in a uniform manner avoiding globs, puddles, and uncoated areas
• FLEECEBACK INSTALLS: When adhering fleece back it is a 2 gallon per square wet dump. The fleeceback products are then set directly into the wet adhesive.
• LIMITATIONS: Temperature needs to be 40F degrees and rising (day & night) and humidity less than 90%.
• Application methods:
• Squeegee Application - Apply with a 1/8 inch notched squeegee to attain specified coverage rate.
• Roller Application - Use a medium nap roller (1/2 inch).
• Spray Application - Follow the manufacturer's safety and use procedures.
• Tip sizes between .019 inch -.023 inch in a Graco 510 gun.
• A minimum fluid pressure of 2,500 psi is required for a fair pattern.
• Back rolling is recommended.
• Flush with water at the end of the day.

Options:

• Container Sizes: 5 Gallon, 1-Quart Can

More Product Information:

• Product Data Sheet
• MSDS Sheet
• General Instructions for Use
• Video Link